|
| [expand all] 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 [index] | |  | | 16.07.2005: Hub nut | |
With the car still on the ground, remove the centre cap from the wheel and
loosen the hub nut using a 32 mm socket (a 1¼" will do) and a
breaker bar. Loosen the wheel bolts while you're at it too (17 mm socket).
|
|
Outer CV boot replacement on a 1996 Saab 900SE turbo. The repair had to be
done because the old boot developed a crack and started leaking grease.
Tools and supplies:
- new CV boot kit: boot, clamps, snap ring and grease;
- 32 mm (1¼") socket: hub centre nut;
- 18 mm socket: tie rod nut;
- 17 mm socket: wheel bolts;
- 15 mm socket: control arm to subframe bolt;
- 13 mm socket: lower sway bar link nut;
- 11 mm open wrench: upper part of sway bar link;
- 10 mm Allen key: caliper bolts;
- 5 mm Allen key: ABS sensor screws, rotor index screw;
- torque wrench;
- car jack and axle stands;
- C-clamp: for tightening the tie rod end;
- breaker bar;
- vice-grips;
- gear puller;
- hammer.
|
|
|
We have a new home on Github! Go right ahead to bookmark and contribute... Or stay here if you like 2000's websites.
