We have a new home on Github! Go right ahead to bookmark and contribute... Or stay here if you like 2000's websites.

[expand all] 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
[index]
Click to see the next picture
04.04.2005: Ignition cover
On the 900, just pry up the ignition lock cover with a small screwdriver. On the 9-3, the cover will be bigger and there's a PCB with key antenna under it. The antenna can be removed by twisting it sideways and pulling it up or by releasing the tabs using a small screwdriver. There's a connector at the bottom.

Adjustable short shifter rod installation on the 1996 Saab 900. Part from MP Performance.

To remove the shifter housing, first lock the transmission in fourth gear and undo the clamp that connects the linkage to the gearshift rod as described in the shifter alignment procedure.

Update: the shifter has been removed a couple of months later due to inadequate performance: the shortening was barely noticeable, and the ball kept getting loose despite the locking screw, which introduced unwanted slop into the shifting feel. If you plan to install this shifter, I'd recommend removing the reverse lockup and putting the ball on Loctite or another adhesive for proper effect.

Update 2: the adjustable shifter rod used in this guide is no longer produced, an alternative (and improved) do-it-yourself modification is available here.

Tools:

  • 13 mm socket: linkage clamp;
  • 13 mm wrench: gearshift rod;
  • 10 mm socket: centre console and shifter housing;
  • long socket extension;
  • ratchet handle;
  • torque wrench;
  • flat screwdriver;
  • Torx T25 screwdriver;
  • two L-shaped 3 mm Allen keys: linkage lock;
  • 2 mm hex key: shifter adjustment;
  • strap wrench and C-clamp: knob removal;
  • needle-nose pliers.

 

 
Copyright © 2000-2013 Dmitry Platonoff
All rights reserved.