|
[expand all] 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48
49 50 51 52 [index] | |  | | 10.02.2005: ABS sensor | |
An engineer who decided to use tiny bolts with a 5 mm Allen head for ABS
sensors should be prosecuted. With this much rust, the head instantly
rounds off when you first attempt to unbolt it, and then snaps
completely when you try to finish the job with vice-grips. To avoid that,
undo the bolt that holds the sensor bracket instead: it's also a 5 mm Allen,
but its thread is not exposed to moisture.
|
|
A front suspension upgrade performed on a 1996 Saab 900SE turbo. The goal
was to replace the old and worn components with
new parts. The
pictures show the work done at the right front corner.
Parts from Taliaferro Imports,
shox.com and
eBay. See also
the rear suspension
installation.
The job took me several days, as you can see from the dates on the
photos. Unfortunately, I was short on spare time and could only spend
a couple of hours a day in the evening. With all the tools at hand, proper
preparations, and without the unexpected interruptions, the work can be done
in one day. A second person would speed things up as well.
Tools and supplies:
- 32 mm (1¼") socket: hub centre nut;
- 24 mm wrench: retainer nut on top of the strut, new outer bushing bolt;
- 18 mm socket: tie rod nut;
- 18 mm wrench: ball joint nut;
- 17 mm socket: wheel bolts;
- 16 mm socket: stanchion arm to subframe bolt;
- 15 mm socket: control arm to subframe bolt;
- 13 mm socket: lower sway bar link nut, strut mount nuts;
- 11 mm socket: top of the original damper rod;
- 11 mm open wrench: upper part of sway bar link;
- 10 mm socket: belt shield screws;
- 10 mm Allen key: caliper bolts;
- 8 mm socket: belt shield screws;
- 7 mm Allen key: top of the Bilstein damper rod;
- 5 mm Allen key: ABS sensor screws, rotor index screw;
- Torx T55 key: original stanchion arm to control arm bolt;
- torque wrench;
- pipe wrench (60 mm): strut insert sleeve nut;
- car jack and axle stands;
- ball joint separator or large Pitman gear puller;
- spring compressor;
- C-clamp: for tightening tie rod ends;
- breaker bar;
- vice-grips;
- large screw extractor (6 mm);
- hammer and rubber mallet;
- loctite, anti-seize, silicone/moly chassis grease, rust solvent.
|
|
|
We have a new home on Github! Go right ahead to bookmark and contribute... Or stay here if you like 2000's websites.
