|
| [expand all] 1 2 3 4 [index] | |  | | 11.07.2006: Installed | |
Install the new filter, fit the clamp and tighten both banjo bolts to 16
ft-lbs. The engine might take a bit longer to start for the first time,
but should be fine afterwards.
|
|
Fuel filter replacement on a 1995 Saab 900. The procedure is the same for
all 1994-1998 900 and 1999-2002 9-3. 9-5s are also very similar, except that
the filter is covered by a plastic shield.
Before starting the work, start the engine and pull the fuel pump fuse.
The engine will eventually use up all fuel in the lines, choke and stall.
This is needed to release the fuel pressure and prevent the petrol from
fountaining from the banjo fittings when you unscrew the filter.
Tools:
- 27 mm wrench: inlet side of the filter;
- 22 mm wrench: exit side of the filter;
- 19 mm socket: inlet banjo bolt;
- 17 mm socket: exit banjo bolt;
- Torx T30 socket: clamp screw;
- car ramps or jack and stands.
|
|
|
We have a new home on Github! Go right ahead to bookmark and contribute... Or stay here if you like 2000's websites.
