|
| [expand all] 1 2 3 4 5 6 7 8 9 10 11 12 [index] | |  | | 15.02.2005: New vs old | |
The comparison between the old and new parts. Not much to comment here,
the Intrax springs are shorter (and of the progressive design), while
the Bilstein dampers are stiffer and visibly stronger.
|
|
A rear suspension upgrade performed on a 1996 Saab 900SE turbo. The goal
was to replace the old and worn components with
new parts. The
pictures show the work done at the right left corner. The job is much easier
than the front,
and takes a couple of hours if you are prepared. Parts from
shox.com and
eBay.
Tools and supplies:
- 17 mm socket: wheel bolts, lower damper nuts;
- 17 mm open wrench: Bilstein upper damper nut;
- 16 mm wrench and socket: original upper damper nut;
- 5 mm Allen key: top of the Bilstein damper rod;
- car jack and axle stands;
- breaker bar;
- torque wrench;
- impact wrench (recommended);
- vice grips;
- several thin metal strips and two pry bars;
- sharp knife or cardboard cutter;
- anti-seize, soap solution, rust solvent.
|
|
|
We have a new home on Github! Go right ahead to bookmark and contribute... Or stay here if you like 2000's websites.
