|
| [expand all] 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 [index] | |  | | 19.01.2005: Front pipe | |
Unbolt the front section of the downpipe from the turbo. Two nuts are
accessible from the top, and one from below. A 13 mm socket was a loose fit,
so I used a 1/2" to escape rounding the nuts off. Two were OK, one was
very tight, but a bit of solvent did the job.
|
|
The downpipe installation procedure for a 1996 Saab 900 (also applies to the
1999-2002 9-3 models). The pipe is supplied by
Jak Stoll.
It is a 3" aluminized steel downpipe with a Magnaflow high flow
catalitic converter.
Tools:
- ramps or jack stands;
- 13 mm socket or wrench: downpipe to turbo nuts, exhaust clamp bolts
(a 1/2" worked better in my case due to a tighter fit);
- 7/8" open end wrench: O2 sensors;
- flat screwdriver: to release the tab on the O2 sensor connector;
- a heavy tool or a length of pipe to bend exhaust hangers;
- wire brush: to clean the joint between the flex pipe and the cat;
- exhaust sealant: to seal the joint between the flex pipe and the cat;
- torque wrench.
|
|
|
We have a new home on Github! Go right ahead to bookmark and contribute... Or stay here if you like 2000's websites.
