|
17.06.2007: Passenger side |
Undo the screws and remove the footwell panel on the passenger side.
|
|
17.06.2007: Driver side |
Remove the footwell panel on the driver side - two more Torx screws.
|
|
17.06.2007: ACC and switches |
Push the climate control panel and switches out from behind. Disconnect
the wires.
|
|
17.06.2007: Tabs |
Release the tabs by pressing on the locking pin in the centre, and pull
them out.
|
|
17.06.2007: Ash tray |
Remove the ash tray in the back of the console and unscrew a Torx screw
in the middle.
|
|
17.06.2007: Nuts |
Undo two 10 mm nuts holding the console to the floor.
|
|
17.06.2007: Switches |
Pop the window switch block, disconnect the harness and move it away.
|
|
17.06.2007: Ignition cover |
Gently pry out the cover over the ignition lock. The 9-3 has a small
circuit in it. Pop the big cover.
|
|
17.06.2007: Ignition cover |
Undo the screws holding the console to the gearshift housing.
|
|
17.06.2007: Light switch |
Pop the light switch and disconnect its wires.
|
|
17.06.2007: Console removed |
List the rear half of the console, then the front half. Remove the
air duct.
|
|
17.06.2007: 4th gear |
Insert the key and move the shifter into 4th gear.
|
|
17.06.2007: Gearbox lock |
Under the hood, pull the plug out of the gearbox locking hole and insert
a long 3 mm Allen key to lock the transmission in 4th gear.
|
|
17.06.2007: Linkage nut |
Slacken the 13 mm nut on the linkage rod and move the shifter into 3rd
gear position to pull the rod out of the linkage.
|
|
17.06.2007: Housing bolts |
Undo the four 10 mm bolts holding the housing to the floor.
|
|
17.06.2007: Ignition harness |
Turn the housing onto its side and disconnect the ignition harness.
|
|
17.06.2007: Removed |
Remove the housing from the car.
|
|
17.06.2007: Shifter housing |
The gearshift housing on the ground.
|