[expand all] 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
[index]
Click to see the next picture
04.04.2005: Knobs out
The ACC panel and the seat heater switches come out of the panel, allowing you to unplug the wires. The ACC fan has a cap that comes off, and then you need to push the fan inside the dash. There are also two connectors on the back of the lighter outlet.

Adjustable short shifter rod installation on the 1996 Saab 900. Part from MP Performance.

To remove the shifter housing, first lock the transmission in fourth gear and undo the clamp that connects the linkage to the gearshift rod as described in the shifter alignment procedure.

Update: the shifter has been removed a couple of months later due to inadequate performance: the shortening was barely noticeable, and the ball kept getting loose despite the locking screw, which introduced unwanted slop into the shifting feel. If you plan to install this shifter, I'd recommend removing the reverse lockup and putting the ball on Loctite or another adhesive for proper effect.

Update 2: the adjustable shifter rod used in this guide is no longer produced, an alternative (and improved) do-it-yourself modification is available here.

Tools:

  • 13 mm socket: linkage clamp;
  • 13 mm wrench: gearshift rod;
  • 10 mm socket: centre console and shifter housing;
  • long socket extension;
  • ratchet handle;
  • torque wrench;
  • flat screwdriver;
  • Torx T25 screwdriver;
  • two L-shaped 3 mm Allen keys: linkage lock;
  • 2 mm hex key: shifter adjustment;
  • strap wrench and C-clamp: knob removal;
  • needle-nose pliers.

 

 
Copyright © 2000-2013 Dmitry Platonoff
All rights reserved.